SensorGnome User Guide
  • Introduction and Overview
  • Connecting to your SensorGnome
  • The Web Interface
  • Establishing an FTP connection
  • Downloading detection data
  • Uploading detection data
  • Installing and updating SensorGnome software
  • Data syncing over the Internet
  • Appendix
    • What to bring
    • Underpowered SensorGnomes
    • Connection and folder path cheatsheet
    • Configuring the SensorGnome frequency
    • CTT LifeTag compatibility (dual-mode)
    • CTT Motus receiver dongles for 434 MHz (dual-mode) capability on SensorGnome
    • Anatomy of a SensorGnome
    • Installing BeagleBone drivers
    • Restoring BeagleBone drivers on Windows
    • Recovering a BeagleBone that can no longer be reimaged
    • Accessing BeagleBone as a network drive
    • Connecting to a BeagleBone using an Ethernet cable
    • Using Bonjour Browser to find the IP address
    • Uploading a local tag database
    • How to build a SensorGnome
    • Reflash FUNcube dongle firmware
    • Motus data file formats
  • How to install the new SensorGnome software
Powered by GitBook
On this page

Was this helpful?

Export as PDF
  1. Appendix

How to build a SensorGnome

PreviousUploading a local tag databaseNextReflash FUNcube dongle firmware

Last updated 4 years ago

Was this helpful?

[placeholder section]

For now, refer to . The content here will eventually be migrated over to this guide.

https://www.instructables.com/Raspberry-Pi-SensorGnome/#solder